Hole Size 150*150mm PLC Reinforced Steel Bar Mesh Welding Machine
Reinforced Steel Bar Mesh Welding Machine Introduction:
This Machine is mainly used to produce steel wire diameter 5.0-12.0mm,material round steel wires and
ribbed steel wires,mesh size:100*100-300*300mm reinforcing mesh panels.
Reinforced Steel Bar Mesh Welding Machine Features:
Line Wires Aligning and Automatic Feed Device
The Line Wires Automatic Feeding Device is to automatically send
the manually threaded line wires to the welding electrode position
of the main mesh welding machine, so as to facilitate the main mesh
welding machine to complete the welding process. When the line
wires feeding car is automatically feeding, the next group of line
wires will be manually prepared, which can realize the production
of the main mesh welding machine without shutdown and greatly
improve the production efficiency.
Line Wires Aligning and Automatic Feeding Device
The Line Wires Automatic Feeding Device is to automatically send
the manually threaded line wires to the welding electrode position
of the main mesh welding machine, so as to facilitate the main mesh
welding machine to complete the welding process. When the line
wires feeding car is automatically feeding, the next group of line
wires will be manually prepared, which can realize the production
of the main mesh welding machine without shutdown and greatly
improve the production efficiency.
Welding electrode
The up and down electrodes all adopts special CuCrZr,the
electricity conductivity,hardness and wear resistance are all very
good,the changeover time of the longitudinal cell is reduced to
about 30 seconds.Welding electrodes are driven by the spindle
passing through the crank,and installed with adjustable spring
pressure,This structure is not affected by climate and convenient
maintenance and usage.
And the up and down electrodes both adopt water cooling system,thus
an reduce the heat of the upper and lower electrodes when the
machine works, and can work for 24 hours continuously.
Pulling Mesh Device
It is to pull the welded cross wires out of the mesh according to
the parameters set by the program, and according to the length of
the mesh, it can realize multiple reciprocating pulling mesh, until
the whole mesh is completely pulled out.
It is composed of four parts: the bottom frame, the movable pulling
mesh frame, thepulling mesh car and the supporting mesh tubes.
Reinforced Steel Bar Mesh Welding Machine Technical Parameters:
Material | Cold and hot rolled low carbon steel wire |
Max. mesh width (cross wire length) | 2500 [mm] |
Min. mesh width (cross wire length) | 1500 [mm] |
Max. mesh length (line wire length) | 6000 [mm]( According to the customer request) |
Min. mesh length (line wire length) | 1500 [mm] |
Line wire spacing | ≥100 [mm], adjustable |
Cross wire spacing | ≥100[mm], programmable adjustable |
Line wire diameter | Φ6- Φ12 [mm] |
Cross wire diameter | Φ6 - Φ12 [mm] |
Max. welding capacity | Φ12+ Φ12 [mm] |
Max. welding speed | 40 - 60 [strokes/min] (cross wire no°/min) |
Air consumption | ≥0.6Mpa, 1.5m 3/min |
Electronic parts specifications: |
Numbers of welding transformer | 12 |
Numbers of electrode | 24 |
Power supply voltage | 380 [V] - 50 [Hz] (According to customer request) |
Total installed power | 150 [KVA]*12 |
Photos of Reinforced Steel Bar Mesh Welding Machine:
